Week 44, Part 2

C&K Roofing also installed our interior metal liner in rooms that will be humid or cleaned with a pressure hose. Here they are installing corner trim to finish the installation in the UV disinfection room-



Here is a wide view of the UV room after All Wall epoxied the lower concrete wall. Some trim is sitting in the lower level waiting for primer. (If any of the metal wall panels look mismatched it’s just the limitation of Photoshop auto-merge!)-



Last week the Belt Filter Press and related equipment were placed inside. This week the piping between the Sludge Pump and the Belt Press was installed-



Back outside Mechanical, Challenger Electric continues routing conduit into the Power & Signal vaults near the east end. You can see 5 total knock-outs in our stem wall below the accent-colored CMU blocks. Any conduit going through these holes takes a 90 bend up into the floor of the Blower room. This is where the Motor Control Center will be installed in a couple weeks-



Here is a secondary duct bank, the one heading towards our Reuse Water Tank on the left and the Effluent Pump Station. I am standing the Effluent vault while taking this picture-



This is a view of the Mechanical building and the grade in front of it (north). Last week this area had several trenches for electrical conduit running to the Generator and Transformer pads (center and center-right) the power vault in front of the propane tanks, and a light pole base just off frame lower left-



A wide view of the Influent Lift Station. Right of frame you can barely see the gate to the existing lagoons. The vaults in the center, right to left, are the Pump vault, a manifold vault where the flow of two pumps in joined, then a metering vault. Challenger is installing conduit for the main power to the Lift Station. A panel rack will be installed near where Brent is workin’ the shovel- (pretty sure it’s Brent?!)



A REALLY wide view from Toetly Road on the left to the lagoons on the right-